Replacing The Slide Motor Assembly (Wiper Arm) - MUTOH Falcon II Outdoor Maintenance Manual

Notes :
Step 4 :
Reinstall all parts in the opposite order of the removal procedure.

4.8.3. Replacing the SLIDE motor assembly (wiper arm)

Caution :
The motor is hot after the product has been operated, so be careful not to burn yourself.
Step 1 :
Follow the instructions in "Replacing the maintenance assembly" to remove the maintenance assembly.
Step 2 :
Remove the 2 screws fixing the SLIDE motor assembly.
1 = SLIDE motor assembly
Step 3 :
Replace the SLIDE motor assembly.
Step 4 :
Reinstall all parts in the opposite order of the removal procedure.
Do not touch the cleaner with your bare hands. Oil or grease adhering to the
surface of the nozzles can cause the nozzles to fall out.
When removing and installing the cleaner, be sure to remove the hook. Failure to
do so could deform the cleaner.
Install the cleaner to the following positions:
50 or 64 inch model: The third, fourth, fifth, sixth from the left
87 inch model: The first, third, fifth, seventh from the left
Be sure to install the cleaner with the rubber part toward the rear.
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M3x6) fixing the SLIDE motor assembly
127 AP-74065, Rev. 1.0, 21/11/03