Connecting The Foot Switch For The Pressure Roller - MUTOH Viper TX Operation Instructions Manual

3.6.2 Connecting the foot switch for the pressure roller

If the pressure roller needs to be raised or lowered, it is possible to control this motion from the foot switch,
instead of doing so at the operation panel.
•
When handling the foot switch, be aware of the following:
o
o
o
Install the foot switch according to following procedure.
Step 1 :
Make sure that the power of the unit is OFF.
•
When the operation panel is in the following condition, the power is ON. Press the key again to turn
the power OFF.
o
Step 2 :
Connect the foot switch cable connector to the foot switch connector at the rear of the unit and fix
into place.
Step 3 :
Place the foot switch on the floor under the stand.
Downloaded From ManualsPrinter.com Manuals
Caution
Do not place anything heavy on the foot switch.
Do not bend the cable of the foot switch with force and do not pull.
Do not place the foot switch near thermal devices.
Notes
The POWER lamp is lit (green).
1 = Foot switch connector
2 = Foot switch cable
Viper TX – Operation Instructions
43
AP-75710, Rev. 1.1, 09/01/2008