Operating Condition Display - MUTOH Falcon II Outdoor Maintenance Manual

9.2.1. Operating condition display

This chapter explains the messages displayed, the items to be confirmed and the remedy.
No. Message
1 Cover Open
2 Set Paper
Phenomenon Check point
The front cover is (1) Check if the
open. cover R/L sensor
assembly comes
on and off properly
when the front
cover is opened
and closed.
(2) Make sure that
cables for the
cover sensor
assembly are
securely
connected.
(3) The Mainboard
assembly may
have a problem.
The lever is up (1) Check the
operation of the
transmission
photosensor for
the lever up/down
via "Test:Sensor"
of the self-
diagnostic
function.
(2) Make sure the
transmission
photosensor at the
lever motor has
been securely
installed.
(3) Check the
sensor element of
the transmission
photosensor at the
lever motor for
contamination.
Falcon II Outdoor series printers – Maintenance Manual
Action
• Adjust the
operating position
of the cover sensor
R/L assembly.
• Securely connect
the cables for the
cover sensor
assembly to
connectors J155
and J156 on the
mainboard
assembly.
• Securely connect
the cover L sensor
to the cover L
cable.
• Replace the
Mainboard
assembly.
• Replace the
transmission
photosensor at the
lever.
• If the
transmission
photosensor is
detached, fix it
securely.
• Clean the sensor
element using
cotton swabs.
277
Refer to
→ Cover sensor
adjustment
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Cover sensor
adjustment
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Replacing the
transmission
photosensor.
→ Replacing the
transmission
photosensor.
→ Replacing the
transmission
photosensor.
AP-74065, Rev. 1.0, 21/11/03