Procedure For Creating Backup Parameters - MUTOH Falcon II Outdoor Maintenance Manual

7.3.2. Procedure for creating backup parameters

This section explains the procedure for recording backup parameters from the Mainboard assembly onto a memory card.
Use the following procedure to create backup parameters.
Important :
Step 1 :
Remove the memory cover.
Step 2 :
Install the memory card for parameter backup into the memory card connector slot (J104) on the mainboard
assembly.
Notes :
Step 3 :
Turn the power to the printer on.
After all of the lamps on the operation panel light up, the LED display on the panel displays
"PRINTER→CARD".
Step 4 :
Press the [ENTER] key on the operation panel.
The LED display on the operation panel displays "P→C Started".
Backup parameter creation begins.
Step 5 :
If the backup parameter has been created correctly, "P→C Completed" is displayed on the operation panel.
Step 6 :
Turn off the power source to the printer.
Step 7 :
Remove the memory card for parameter backup.
Notes :
Before replacing parts, be sure to perform the following operations.
Turn the machine power OFF.
Remove the product's electrical plug from the socket. Otherwise, you
may suffer electric shock or the machine's electric circuits may be
damaged.
Disconnect all cables from the machine. Not doing so could cause damage to
the printer.
Install the memory card so that its front is toward the inside of the printer.
If you do not have backup memory card, output "Adj. Variable" in "Sample Printing
Menu". Required parameter is output.
For the panel setting value, output "Setup" in the Operation Manual. Maintenance
history is not printed.
Falcon II Outdoor series printers – Maintenance Manual
229 AP-74065, Rev. 1.0, 21/11/03