Replacing The Steel Belt - MUTOH Falcon II Outdoor Maintenance Manual

Notes :

4.6.2. Replacing the steel belt

Caution :
When replacing the steel belt, be careful not to cut your hands by the belt.
Notes :
Step 1 :
Unlock the head.
Notes :
Step 2 :
Move the carriage from the capping position to the left.
Step 3 :
Rotate the 2 steel belt adjustment screws counterclockwisely to loosen the steel belt.
When installing the CR motor cable assembly connector, install the white cable on
the right side as shown in the previous figure.
Do not damage the steel belt.
Remove following covers before replacing the steel belt.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Refer to 'Head Lock Menu'
Falcon II Outdoor series printers – Maintenance Manual
91 AP-74065, Rev. 1.0, 21/11/03