Replacing The Waste Bottle Box Sensor Assembly (F2O 2H) - MUTOH Falcon II Outdoor Maintenance Manual

4.11.3. Replacing the waste bottle box sensor assembly (F2O 2H)

Step 1 :
Follow the instructions in "Replacing the waste fluid bottle assembly" to remove the waste fluid bottle assembly.
Step 2 :
Remove the waste liquid BOX sensor assembly connector from the rear side cap R.
1 = Rear side cap R
Step 3 :
Remove the screws (3 at the front and 12 at the right and left) fixing the waste liquid bottle cover.
1 = Waste liquid bottle cover
Step 4 :
Remove the waste liquid bottle cover.
Step 5 :
Remove the screws (2) fixing the waste liquid sensor installation board.
1 = Screws fixing the waste liquid sensor installation board (M3x6)
Falcon II Outdoor series printers – Maintenance Manual
2 = Waste liquid BOX sensor assembly connector
2 = Screws (M3x6)
139 AP-74065, Rev. 1.0, 21/11/03