Replacing The P_Edge Sensor Assembly - MUTOH Falcon II Outdoor Maintenance Manual

4.7.6. Replacing the P_EDGE sensor assembly

Notes :
Step 1 :
Remove the P_EDGE sensor assembly connector from the CR board assembly.
Step 2 :
Remove the screw fixing the P_EDGE sensor assembly.
Step 3 :
Replace the P_EDGE sensor assembly.
1 = P_EDGE sensor assembly
Step 4 :
Reinstall all parts in the opposite order of the removal procedure.
Step 5 :
Perform media sensor sensitivity adjustment according to "Media sensor sensitivity adjustment".
Remove following covers before replacing the P_EDGE sensor Assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Head cover: refer to "Removing the head cover"
Falcon II Outdoor series printers – Maintenance Manual
2 = Screw (M2x12) fixing the P_EDGE sensor
assembly
115 AP-74065, Rev. 1.0, 21/11/03