Cr Motor Endurance Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.9.1. CR Motor Endurance Menu

This menu performs endurance running for the CR motor.
You can perform carriage stroke according to your desired setting. The available settings are shown below.
Setup item
Operation speed (CW,
CCW)
Number of endurance
running cycles
Notes :
* Speed CW *
Speed
* Speed CCW *
Speed
* Aging Count *
Count
* CR Motor *
Count
* CR Motor *
End
Description
Sets carriage operation
speed (CW and CCW).
Set the number of
endurance running
cycles
If the number of endurance running cycles has been set to -1, the units continuously
repeat endurance running until a key input is given from the operation panel.
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
↓ ENTER
↓ ENTER
↓ ENTER
↓ ENTER
Falcon II Outdoor series printers – Maintenance Manual
Parameters
240, 300
-1 to 10000
240 / 300 + Speed (CW)
240 cps -
240 / 300 + Speed (CCW)
240 cps -
-1 → 10000 + Number of endurance running cycles
50 -
5 Perform endurance running
50
198
Remarks
Unit: cps
AP-74065, Rev. 1.0, 21/11/03