Removing The Head Cover - MUTOH Falcon II Outdoor Maintenance Manual

4.2.10. Removing the head cover

Step 1 :
Remove the I/H cover.
Step 2 :
Remove side cover R.
Step 3 :
Remove side cover L.
Step 4 :
Remove the front cover.
Step 5 :
Remove the carriage cover.
Step 6 :
Remove the Y rail cover.
Step 7 :
Unlock the head.
Step 8 :
Pull the head out to the left of the maintenance station.
Step 9 :
Remove the 2 screws fixing the head cover.
Caution :
Please note that this cover is only on a Falcon II Outdoor (2 heaters) printer.
Notes :
Please refer to the 'Head lock menu'.
Caution :
When pulling the head out, do not press on the cutter cap. Doing so could damage the
cutter blade.
52
Falcon II Outdoor series printers – Maintenance Manual
AP-74065, Rev. 1.0, 21/11/03