Falcon Ii Outdoor 4 Heaters : Heater Elements - MUTOH Falcon II Outdoor Maintenance Manual

Step 9 :
Stick (with silicone glue) the two press plates onto the heater strip.
50" model : X = 380 mm
64" model : X = 380 mm / Y = 1060 mm
87" model : X = 660 mm / Y = 1200 mm / Z = 1750 mm
Step 10 :
Reinstall all parts in the opposite order of the removal procedure.

4.3.2. Falcon II Outdoor 4 heaters : Heater elements

4.3.2.1. Replacing the dryer (Heater D) on a Falcon II Outdoor 4H printer
Before replacing the dryer, make sure to have following items:
50" model : Dryer D1 50 (EY-80346) and Dryer D2 50 (EY-80347)
64" model : Dryer D1 64 (EY-80341) and Dryer D2 64 (EY-80342)
87" model : Dryer D1 87 (EY-80356) and Dryer D2 87 (EY-80357)
2 x sensor insul. Patch (ME-80310)
To replace the dryer on a Falcon II Outdoor 4H printer, please follow the instructions mentioned below.
Step 1 :
Remove side cover L.
Step 2 :
Remove side cover R.
Step 3 :
Remove the front cover.
Step 4 :
Remove the Y rail cover.
Notes :
It will take ± 1 hour to let the glue dry.
Notes :
During reinstallation of the plate, make sure there are no cables stuck.
58
Falcon II Outdoor series printers – Maintenance Manual
AP-74065, Rev. 1.0, 21/11/03