Maintenance Mode; Introduction; Operating Maintenance Mode; Starting Up Maintenance Mode - MUTOH Falcon II Outdoor Maintenance Manual

6.1. INTRODUCTION

This chapter provides information on the maintenance mode.
The maintenance mode provides the user with functions of displaying and initializing the life counters.
It is used in the manufacturing process, adjustment and maintenance.
The maintenance mode is implemented in the system firmware. All functions are available from the operation panel.
Notes :
Refer to "Operation Panel ".

6.2. OPERATING MAINTENANCE MODE

This section explains how to start up and operate the maintenance mode and provides the list of available diagnosis items.

6.2.1. Starting Up Maintenance Mode

To use the maintenance mode, you should first call up the maintenance menu on the operation panel.
The maintenance menu is completely independent of the normal operation mode and setup menu display mode. To call up
the maintenance menu, follow the steps below.
Step 1 :
If the system is in the operation mode or the setup menu mode, press the [POWER] key.
Step 2 : Press and hold the [F1] key, [F3] key and [MENU ↑] key simultaneously. While holding down these keys, press
the [POWER] key.
The system will enter the maintenance mode and display the maintenance menu.
Falcon II Outdoor series printers – Maintenance Manual

6. MAINTENANCE MODE

216 AP-74065, Rev. 1.0, 21/11/03