Warning Labels; Handling The Operation Procedure Labels; Locations And Types Of Operation Procedure Labels - MUTOH Falcon II Outdoor Maintenance Manual

 M ake sure that the power of the printer is OFF before installing the firmware. Installing the firmware with the power ON
may damage the main substrate assembly or data may not be properly installed.
 E nsure there is sufficient space around the printer when performing maintenance work.
 M aintenance must be done by more than one person for :
detaching the printer from the stand or attaching it.
packing the printer for transportation.

1.4. WARNING LABELS

The handling, attachment locations, and types of warning labels are explained below.
Warning labels are attached to areas to which attention should be paid. Read and understand the positions and contents
thoroughly.

1.4.1. Handling the operation procedure labels

Notes :
Make sure that all labels can be recognized. If text or illustrations are invisible,
clean or replace the label.
When cleaning labels, use a cloth with water or neutral detergent. Do not use a
solvent or gasoline.
If a warning label has been damaged, lost or cannot be recognized, replace the
label.

1.4.2. Locations and types of operation procedure labels

The locations of warning labels are shown below.
(1) Front Part
Falcon II Outdoor series printers – Maintenance Manual
13 AP-74065, Rev. 1.0, 21/11/03