Replacing The Transmission Photosensor - MUTOH Falcon II Outdoor Maintenance Manual

4.5.8. Replacing the transmission photosensor

Notes :
(1) Replacing the transmission photosensor (lever motor side)
Step 1 :
Remove the screw fixing the sensor installation board.
1 = Sensor installation board
Step 2 :
Remove the sensor installation board.
Step 3 :
Remove the transmission photosensor from the sensor installation board.
1 = Sensor installation board
3 = Transmission photosensor
Step 4 :
Remove the connector from the transmission photosensor.
Step 5 :
Remove the transmission photosensor.
Remove following covers before replacing the transmission photosensor.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Falcon II Outdoor series printers – Maintenance Manual
2 = Screw (M3x8) fixing the sensor installation board
2 = Connector
86 AP-74065, Rev. 1.0, 21/11/03