Replacing The Cr Cursor Assembly - MUTOH Falcon II Outdoor Maintenance Manual

4.7.7. Replacing the CR cursor assembly

Notes :
Step 1 :
Follow the instructions in "Replacing the cutter holder, cutter spring, cutter cap, solenoid assembly, and solenoid
spring" to "Replacing the P_EDGE sensor assembly " to remove the parts in cursor components.
Step 2 :
Slide the CR cursor assembly to the opposite side of the home position.
Step 3 :
Follow the instructions in "Replacing the steel belt" to remove the steel belt from the CR cursor.
Step 4 :
Remove the 4 screws fixing the CR board installation board.
Step 5 :
Remove the CR board installation board.
1 = CR board installation board
Step 6 :
Remove the T fence.
Remove following covers before replacing the CR cursor assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Head cover: refer to "Removing the head cover"
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M3x8) fixing the CR board installation
board
116 AP-74065, Rev. 1.0, 21/11/03