Replacing The Suction Fan Assembly - MUTOH Falcon II Outdoor Maintenance Manual

1 = P_REAR_R sensor assembly
Step 5 :
Replace the P_REAR_R sensor assembly.
Step 6 :
Use the same procedure to replace the P_REAR_L sensor assembly.
Step 7 :
Reinstall all parts in the opposite order of the removal procedure.

4.5.6. Replacing the suction fan assembly

Step 1 :
Remove the suction fan assembly connector from the suction fan cable assembly.
Step 2 :
If replacing the suction fan cable assembly, first remove the connector from the Mainboard assembly.
Step 3 :
Remove the 2 screws fixing the suction fan assembly.
1 = Suction fan assembly
Step 4 :
Replace the suction fan assembly.
Step 5 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
Remove following covers before replacing the suction fan assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Media guide F: refer to "Removing media guide F"
83
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M2x5) fixing the P_REAR_R sensor assembly
2 = Screws (M3x12) fixing the suction fan assembly
AP-74065, Rev. 1.0, 21/11/03