Lever Motor Endurance Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.9.7. Lever Motor Endurance Menu

This menu performs endurance running for the lever motor.
You can drive the lever motor according to your desired settings. The available settings are shown below.
Setup item
Number of endurance
running cycles
Notes :
* LifeCount *
Count
* LeverMotor *
Count
* LeverMotor *
End
Description
Set the number of
endurance running
cycles
If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
-1 → 10000 +
↓ ENTER
↓ ENTER or CANCEL
Falcon II Outdoor series printers – Maintenance Manual
Parameters
-1 to 10000
Number of endurance running cycles
50 -
5 Perform endurance running
50
205
Remarks
AP-74065, Rev. 1.0, 21/11/03