Replacing The Cr Slave Pulley Assembly - MUTOH Falcon II Outdoor Maintenance Manual

4.6.5. Replacing the CR slave pulley assembly

Notes :
Step 1 :
Follow the instructions in "Replacing the steel belt" to remove the steel belt.
Step 2 :
Replace the CR slave pulley assembly.
1 = CR slave pulley assembly
3 = Bearing stopper
Step 3 :
Reinstall all parts in the opposite order of the removal procedure.
Step 4 :
Perform steel belt tension adjustment according to "Steel belt tension adjustment".
Notes :
Remove following covers before replacing the CR slave pulley assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Be careful when handling the steel belt. The steel belt may be cut off when
accreting dust to it or creasing it.
The driven pulley shaft is installed one way only. Refer to "Service Parts
List/Exploded Views/Configuration Diagrams", to install it correctly so that the
bearing stoppers are on top.
After installing the CR slave pulley assembly, move the carriage to the left and right
manually to confirm that the steel belt has been set equally in the center of the CR
actuator pulley and the CR slave pulley assembly.
Falcon II Outdoor series printers – Maintenance Manual
2 = Steel belt
98 AP-74065, Rev. 1.0, 21/11/03