Replacing Supports And Scroller; Replacing The Waste Fluid Bottle Assembly (Falcon Ii Outdoor 2H) - MUTOH Falcon II Outdoor Maintenance Manual

Step 9 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
Step 10 :
Make sure that the Ink NOT sensor switch moves.

4.11. REPLACING SUPPORTS AND SCROLLER

4.11.1. Replacing the waste fluid bottle assembly (Falcon II Outdoor 2H)

Notes :
Step 1 :
Remove the waste fluid tube from the waste fluid bottle assembly.
1 = Waste fluid tube
Step 2 :
Replace the waste fluid bottle assembly.
Caution :
Waste ink will remain inside the tubes. Be careful that the ink is not spilled from the tube
onto the printer or items close to the printer.
Step 3 :
Reinstall all parts in the opposite order of the removal procedure.
When installing the ink NOT sensor, do not tighten the screw tightly. Otherwise, the
switch may not come out.
When replacing the waste fluid bottle assembly, be sure to perform following
operation to clear the counter. "High ink initialization" or " Cleaning initialization":
refer to "Counter Initialization Menu"
137
Falcon II Outdoor series printers – Maintenance Manual
2 = Waste fluid bottle assembly
AP-74065, Rev. 1.0, 21/11/03