Part Names And Functions; Front - MUTOH Falcon II Outdoor Maintenance Manual

2.3. PART NAMES AND FUNCTIONS

Part names and functions are explained below.

2.3.1. Front

No.
1 Operation panel
2 Ink compartment
3 Front cover
4 Pressure rollers
5 Maintenance cover
6 Stand
Name
This panel is used to set operational conditions, the status of the printer,
and other functions.
This is the place for installing ink cartridges.
This cover keeps the operator safe from the drive parts of the printer
while it is operating. Only open and/or close the cover to perform
following operations:
Media setting and replacement
Cutter blade replacement
Cleaning the cleaning wiper
In case of media jam.
This roller is used to press the media from above and keep it flat when
printing.
This protects users from electric shocks caused by touching the internal
electrical parts. The cover is opened when expansion memory
(optional) has to be installed, and is closed for normal use.
This stand is used to install the printer on a surface flat floor.
The following options are available for installation.
Take-up system + scroller receiver
Motorized roll-off / roll-up system
Falcon II Outdoor series printers – Maintenance Manual
18
Function
AP-74065, Rev. 1.0, 21/11/03