Sensor Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.4.4. Sensor Menu

This menu displays the sensor status in the operation panel.
If the displayed sensor status does not match the actual machine status, replace or adjust the relevant sensor referring to
"Table Inspection Items in Sensor Menu".
N° Sensor name
CR_HP sensor
Waste fluid sensor
Cover sensor
Ink cover sensor
Lever Up
Lever Down
Foot lever SW sensor
P_EDDE sensor
P_REAR-R sensor
P_REAR-L sensor
HD_SLIDE sensor
Head thermistor
Ink ID sensor
(1,2,3,4,5,6,7,8)
Ink NOT sensor
Ink END sensor
Notes :
Status in display
ON/OFF
ON/OFF
Open/Close
Open/Close
ON/OFF
ON/OFF
ON/OFF
0 to FF (0 to 255)
ON/OFF
ON/OFF
ON/OFF
**°C
Pig, Dye, WASH
12345678
12345678
The ink ID sensor indicates the type of ink cartridge installed with the following ID.
•
WASH: Cleaning fluid
•
Pig: Pigment system ink
•
Dye: Dye system ink
The ink NOT sensor indicates the number where a cartridge is missing.
For the ink end sensor, the colour of the ink that has run out is displayed.
* Sensor *
CR Origin
Waste Bin
* Sensor *
Wiper
Cap
Falcon II Outdoor series printers – Maintenance Manual
Refer to
Replacing the transmission photosensor
Replacing the waste liquid BOX sensor assembly
Replace the cover R sensor assembly and the
cover L sensor assembly
Removing the I/H cover
Replacing the transmission photosensor
Replacing the transmission photosensor
Replacing the P_EDGE sensor assembly
Replacing the P_REAR_R sensor assembly and
P_REAR_L sensor assembly
Replacing the P_REAR_R sensor assembly and
P_REAR_L sensor assembly
Replacing the SLIDE motor assembly, HD_SLIDE
sensor assembly and slide motor installation board
Replacing the Cartridge Area
Replacing the Cartridge Area
Replacing the Cartridge Area
Off CR_HP sensor
On Waste fluid sensor
(1/12)
On Wiper sensor
Off Cap sensor
(2/12)
156 AP-74065, Rev. 1.0, 21/11/03