7.6. PF DECELERATION BELT TENSION ADJUSTMENT
The procedure for adjusting the tension of the PF deceleration belt is explained below.
When removing the PF motor or removing/installing the PF deceleration belt, adjust the tension of the PF deceleration belt.
7.6.1. Tools required for work
The following tools are required to adjust the tension of the PF deceleration belt.
Tension gauge: max. 50 N (5 kgf)
Notes :
Refer to "Jig and tool list"
7.6.2. Adjustment Procedure
Use the following procedure to adjust the tension of the PF deceleration belt.
Step 1 :
Loosen the 2 screws fixing the PF motor installation board.
Step 2 :
Install the tension gauge on the PF motor installation board and pull it in the direction shown on the figure
below.
1 = PF deceleration belt
3 = PF motor installation board
Notes :
The regulated value of the tension for the PF deceleration belt is 34.32 N ± 1 0 % (3,5
kgf ± 1 0 %).
Step 3 :
Tighten the 2 screws fixing the PF motor installation board.
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M3x6) fixing the PF motor installation
board
4 = Tension gauge
238
AP-74065, Rev. 1.0, 21/11/03