Replacing The Pf Actuator; Replacing The Pf Motor Assembly - MUTOH Falcon II Outdoor Maintenance Manual

4.5. REPLACING THE PF ACTUATOR

4.5.1. Replacing the PF motor assembly

Step 1 :
Remove the PF motor assembly connector from the PF motor cable assembly.
Step 2 :
Remove the 2 screws fixing the X motor installation board to the side of the L side frame.
1 = Screws (M4x10) fixing the X motor installation
board to the side of the L side frame.
3 = PF deceleration belt
Step 3 :
Remove the 2 screws fixing the PF motor assembly to the X motor installation board.
Step 4 :
Replace the PF motor assembly.
Caution :
The motor is hot after the product has been operated, so be careful not to burn yourself.
Notes :
Remove following covers before replacing the parts in the PF motor assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Media guide F: refer to "Removing media guide F"
76
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M4x10) fixing the PF motor assembly to
the X motor installation board.
AP-74065, Rev. 1.0, 21/11/03