Pump Endurance Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.9.6. Pump Endurance menu

This menu performs endurance running for the pump.
In the Pump Endurance menu, you can perform the pump motor assembly endurance operation according to the settings.
The available settings are shown below.
Setup item
Operation speed
Number of endurance
running cycles
Notes :
* Aging pump *
F1 → High
F3 → Low
* LifeCount *
Count
* High *
Count
* High *
End
Description
Sets the operation speed
of the pump motor
assembly.
Set the number of
endurance running
cycles
If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
↓ Select speed (high)
-1 → 10000 +
↓ ENTER
↓ ENTER or CANCEL
Falcon II Outdoor series printers – Maintenance Manual
Parameters
High/Normal/Low
-1 to 10000
Normal ← F2
Number of endurance running cycles
50 -
5 Perform endurance running
50
204
Remarks
AP-74065, Rev. 1.0, 21/11/03