Sequential Printing Endurance Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.9.8. Sequential Printing Endurance Menu

This menu performs endurance running for the printer heads.
You can operate the printer heads according to your desired settings. The available settings are shown below.
Setup item
Printing mode
Media Cut
Number of endurance
running cycles
Notes :
* Print Mode *
F1 → MODE1
F3 → MODE3
* Print Mode *
F1 →
MODE6
* Cut *
Cut
* Nozzle *
Count
Description
Set printing mode.
Sets whether to cut
media each time one
printing is printed out or
not.
Set the number of
endurance running
cycles
If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
MODE2
MODE5
MODE7
↓ Select mode
Yes/No +
↓ ENTER
-1 → 10000 +
↓ ENTER
Falcon II Outdoor series printers – Maintenance Manual
Parameters
MODE 1, MODE 2,
MODE 3, MODE 5,
MODE 6, MODE 7
Yes, No
-1 to 10000
← F2
← F4
(1/2)
← F2
(2/2)
Yes -
Number of endurance running cycles
50 -
206
Remarks
AP-74065, Rev. 1.0, 21/11/03