Parameter Backup; Tools Required For Work - MUTOH Falcon II Outdoor Maintenance Manual

7.3. PARAMETER BACKUP

This chapter explains the different types of parameter backup methods.
The different backup parameters related to the operation of the printer are recorded on the NVRAM (Flash-ROM or
EEPROM) installed on the Mainboard.
There are the following types of backup parameters.
Panel setting values
Mechanism adjustment values
Mainboard adjustment values
Notes :
For the backup parameter, the Mainboard adjustment values cannot be changed or
deleted.
If it is necessary to replace the Mainboard while performing maintenance work, make a parameter backup. You can
shorten some of the adjustment procedures by matching the printer mechanism with the new Mainboard.
Caution :
Before making a parameter backup, make sure that the power source to the printer is
off. If the operation is performed with the power source on, the Mainboard could be
damaged and the data may not be installed correctly.

7.3.1. Tools required for work

The following tools are required for the parameter backup procedure.
Flash memory card
Notes :
Refer to 'Jig and tool list'.
Use the memory card written in "Procedure for creating backup parameters" for
parameter backup of the unit only.
Falcon II Outdoor series printers – Maintenance Manual
228 AP-74065, Rev. 1.0, 21/11/03