Problems Relating To The Printing Operation - MUTOH Falcon II Outdoor Maintenance Manual

9.3.3. Problems relating to the printing operation

No. Phenomenon
1 Continuous printing cannot be
performed.
2 Give an extra feed after the
printing operation has been
completed.
3 Dots are missed in printing
Falcon II Outdoor series printers – Maintenance Manual
Check point Action
(1) The program • Upgrade the
ROM may have firmware version.
failed.
(2) The Mainboard • Replace the
assembly may have Mainboard
a problem. assembly.
(1) Check if the • Make sure that the
detection function of connections of
the P_REAR sensor Mainboard
assembly is correct assembly
via "Test:Sensor" of connectors J128 –
the self-diagnostic J129 are good.
function. • Replace the
P_REAR sensor
assembly.
(2) Check • Adjust the
adjustments of the positions of the top
top & bottom and & bottom and rear
rear sensor sensors.
positions.
(3) The program • Upgrade the
ROM may have firmware version.
failed.
(4) The Mainboard • Replace the
assembly may have Mainboard
a problem. assembly.
(1) Perform the • When the nozzle
printing operation check pattern is not
via "Print:Nozzle printed correctly : go
Check" or to step 2
"Test:Print" of the
self-diagnostic
function.
310
Refer to
→ Firmware
installation.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly.
→ Replacing the
P_REAR_R sensor
assembly and
P_REAR_L sensor
assembly.
→ Top & bottom
adjustment menu.
→ P_REAR sensor
position adjustment
menu.
→ Firmware
installation
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly.
→ Test printing
menu
AP-74065, Rev. 1.0, 21/11/03