Supermicro SSE-G2252 User Manual page 138

SSE-G2252/SSE-G2252P Switches User's Manual
• When mirroring port traffic, the target port must be included in the same VLAN as
the source port when using MSTP (see
page 9-1).
• When mirroring VLAN traffic (see
page 7-27) or packets based on a source MAC address (see
"Configuring MAC Address Mirroring" on page
the same target ports as that used for port mirroring by this command.
• When traffic matches the rules for both port mirroring, and for mirroring of VLAN
traffic or packets based on a MAC address, the matching packets will not be sent to
target port specified for port mirroring.
Parameters
These parameters are displayed in the web interface:
• Source Port – The port whose traffic will be monitored.
(SSE-G2252/P: 1-52)
• Target Port – The port that will mirror the traffic on the source port.
(SSE-G2252/P: 1-52)
• Type – Allows you to select which traffic to mirror to the target port, Rx (receive), Tx
(transmit), or Both. (Default: Rx)
Web Interface
To configure a local mirror session:
1. Click I
NTERFACE
2. Select A
DD
3. Specify the source port.
4. Specify the monitor port.
5. Specify the traffic type to be mirrored.
6. Click A
PPLY
> P > M
ORT IRROR
from the Action List.
.
Figure 6-5. Configuring Local Port Mirroring
Chapter 9: "Spanning Tree Algorithm" on
Section 7-6: "Configuring VLAN Mirroring" on
8-6), the target port cannot be set to
.
6-8
Section 8-5: