Supermicro SSE-G2252 User Manual page 196

SSE-G2252/SSE-G2252P Switches User's Manual
• Configured MAC addresses cannot be broadcast or multicast addresses.
• When MAC-based, IP subnet-based, and protocol-based VLANs are supported
concurrently, priority is applied in this sequence, and then port-based VLANs last.
Parameters
These parameters are displayed in the web interface:
• MAC Address – A source MAC address which is to be mapped to a specific VLAN.
The MAC address must be specified in the format xx-xx-xx-xx-xx-xx.
• VLAN – VLAN to which ingress traffic matching the specified source MAC address
is forwarded. (Range: 1-4093)
• Priority – The priority assigned to untagged ingress traffic.
(Range: 0-7, where 7 is the highest priority; Default: 0)
Web Interface
To map a MAC address to a VLAN:
1. Click VLAN > MAC-B
2. Select A
DD
3. Enter an address in the MAC A
4. Enter an identifier in the VLAN field. Note that the specified VLAN need not already
be configured.
5. Enter a value to assign to untagged frames in the P
6. Click A
PPLY
To show the MAC addresses mapped to a VLAN:
1. Click VLAN > MAC-B
2. Select S
HOW
.
ASED
from the Action list.
.
Figure 7-20. Configuring MAC-Based VLANs
.
ASED
from the Action list.
field.
DDRESS
7-26
field.
RIORITY