Supermicro SSE-G2252 User Manual page 235

Parameters
These parameters are displayed in the web interface:
• Interface – Displays a list of ports or trunks.
• Type – Indicates interface type. (100Base-TX, 1000Base-T, or SFP)
• Unknown Unicast – Specifies storm control for unknown unicast traffic.
• Multicast – Specifies storm control for multicast traffic.
• Broadcast – Specifies storm control for broadcast traffic.
• Status – Enables or disables storm control. (Default: Disabled)
• Rate – Threshold level as a rate; i.e., kilobits per second.
(Range: 64-100000 Kbps for Fast Ethernet ports,
64-1000000 Kbps for Gigabit Ethernet ports)
NOTE: Only one rate is supported for all traffic types on an interface.
Web Interface
To configure broadcast storm control:
1. Click > C
RAFFIC
2. Set the S
TATUS
3. Set the required threshold beyond which the switch will start dropping packets.
4. Click A .
PPLY
C
ONGESTION ONTROL
field to enable or disable storm control.
Figure 10-2. Configuring Storm Control
Chapter 10: Congestion Control
> S C
TORM ONTROL
10-5
.