Supermicro SSE-G2252 User Manual page 142

SSE-G2252/SSE-G2252P Switches User's Manual
• Type – Specifies the traffic type to be mirrored remotely. (Options: Rx, Tx, Both)
• Destination Port – Specifies the destination port
from the source ports. Only one destination port can be configured on the same
switch per session, but a destination port can be configured on more than one
switch for the same session. Also note that a destination port can still send and
receive switched traffic, and participate in any Layer 2 protocols to which it has been
assigned.
• Tag – Specifies whether or not the traffic exiting the destination port to the
monitoring device carries the RSPAN VLAN tag.
Web Interface
To configure a remote mirror session:
1. Click I
NTERFACE
2. Set the S
WITCH
3. Configure the required settings for each switch participating in the RSPAN VLAN.
4. Click A
PPLY
Figure 6-8. Configuring Remote Port Mirroring (Source)
> RSPAN.
R to N , S
OLE ONE
.
1
to monitor the traffic mirrored
, I
OURCE NTERMEDIATE
6-12
, or D .
ESTINATION