Supermicro SSE-G2252 User Manual page 192

SSE-G2252/SSE-G2252P Switches User's Manual
Command Usage
• When creating a protocol-based VLAN, only assign interfaces using this
configuration screen. If you assign interfaces using any of the other VLAN menus
such as the VLAN Static table
protocol type into the associated VLAN.
• When a frame enters a port that has been assigned to a protocol VLAN, it is
processed in the following manner:
• If the frame is tagged, it will be processed according to the standard rules
applied to tagged frames.
• If the frame is untagged and the protocol type matches, the frame is forwarded
to the appropriate VLAN.
• If the frame is untagged but the protocol type does not match, the frame is
forwarded to the default VLAN for this interface.
Parameters
These parameters are displayed in the web interface:
• Interface – Displays a list of ports or trunks.
• Port – Port Identifier. (SSE-G2252/P: 1-52)
• Trunk – Trunk Identifier. (Range: 1-12)
• Protocol Group ID – Protocol Group ID assigned to the Protocol VLAN Group.
(Range: 1-2147483647)
• VLAN ID – VLAN to which matching protocol traffic is forwarded. (Range: 1-4093)
Web Interface
To map a protocol group to a VLAN for a port or trunk:
1. Click VLAN > P
2. Select C
ONFIGURE
3. Select A
DD
4. Select a port or trunk.
5. Enter the identifier for a protocol group.
6. Enter the corresponding VLAN to which the protocol traffic will be forwarded.
7. Click A
PPLY
(page
.
ROTOCOL
I from the Step list.
NTERFACE
from the Action list.
.
7-6), these interfaces will admit traffic of any
7-22