SSE-G2252/SSE-G2252P Switches User's Manual
Edit Member by Interface Range
All parameters are the same as those described under the earlier section for Modify
VLAN and Member Ports, except for the items shown below.
•
Port Range – Displays a list of ports. (SSE-G2252/P: 1-52)
•
Trunk Range – Displays a list of ports. (Range: 1-12)
NOTE: The PVID, acceptable frame type, and ingress filtering parameters for
each interface within the specified range must be configured on either the
Modify VLAN and Member Ports or Edit Member by Interface page.
Web Interface
To configure static members by the VLAN index:
1. Click VLAN > S
2. Select M
ODIFY
3. Set the Interface type to display as P
4. Modify the settings for any interface as required. Remember that M
cannot be changed until an interface has been added to another VLAN and the
PVID changed to anything other than 1.
5. Click A
PPLY
Figure 7-4. Configuring Static Members by VLAN Index
To configure static members by interface:
1. Click VLAN > S
2. Select E
DIT
.
TATIC
VLAN and M
EMBER
.
.
TATIC
M
I
EMBER BY
NTERFACE
P
from the Action list.
ORTS
or T
.
ORT
RUNK
from the Action list.
7-8
T
EMBERSHIP
YPE