CLI References
See
Chapter 28: "Link Aggregation Commands" on page 28-1
"Interface Commands" on page 27-1
Command Usage
•
When configuring static trunks, you may not be able to link switches of different
types, depending on the manufacturer's implementation. However, note that the
static trunks on this switch are Cisco EtherChannel compatible.
•
To avoid creating a loop in the network, be sure you add a static trunk via the
configuration interface before connecting the ports, and also disconnect the ports
before removing a static trunk via the configuration interface.
Parameters
These parameters are displayed in the web interface:
•
Trunk ID – Trunk identifier. (Range: 1-12)
•
Trunk Member Port List – The ports assigned to a trunk.
Web Interface
To create a static trunk:
1. Click I
NTERFACE
2. Select C
ONFIGURE
3. Enter a trunk identifier, and click A
4. Mark the ports assigned to each trunk.
5. Click A
.
PPLY
Figure 6-14. Configuring Static Trunks
statically
configured
active
links
for CLI reference information.
> T
> S
.
RUNK
TATIC
T
from the Step list.
RUNK
DD
6-21
Chapter 6: Interface Configuration
.
and
Chapter 27: