Supermicro SSE-G2252 User Manual page 200

SSE-G2252/SSE-G2252P Switches User's Manual
Parameters
These parameters are displayed in the web interface:
• VLAN – ID of configured VLAN. (Range: 1-4093)
• Interface – Port or trunk associated with the device assigned a static address.
• MAC Address – Physical address of a device mapped to this interface. Enter an
address in the form of xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
• Static Status – Sets the time to retain the specified address.
• Delete-on-reset - Assignment lasts until the switch is reset.
• Permanent - Assignment is permanent. (This is the default.)
W I
EB NTERFACE
To configure a static MAC address:
1. Click MAC A
2. Select A
DD
3. Specify the VLAN, the port or trunk to which the address will be assigned, the MAC
address, and the time to retain this entry.
4. Click A
PPLY
To show the static addresses in MAC address table:
1. Click MAC A
2. Select S
HOW
> S .
DDRESS TATIC
from the Action list.
.
Figure 8-1. Configuring Static MAC Addresses
> S .
DDRESS TATIC
from the Action list.
8-2