Reset Button; Console Port - Supermicro SSE-G2252 User Manual

Reset Button

If you encounter any switch malfunctions, such as a hang or non-recoverable error, you
might want to reset the switch to its default configuration by pressing and holding the
reset button for six seconds. The reset button is located on the rear panel on the
opposing side of the power inlet as shown in

Console Port

This port is used to connect a console device to the switch through a serial cable and is
shown in . The console device can be a PC or workstation running a VT- 100 terminal
emulator, or a VT-100 terminal. A crossover RJ-45 to DB-9 cable is supplied with the
unit for connecting to the console port.
Figure
Figure 1-3. Reset Button
Figure 1-4. Console Port
1-3.
SSE-G2252
Console Port