Show Config - Dell Force10 S4810P Reference Manual

description
Defaults Not configured.
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.4.1.0
Usage The remark command is available in each ACL mode. You can configure up to 4294967290
Information
remarks in a given ACL.
The example below shows the use of the remark command twice within CONFIGURATION-
STANDARD-ACCESS-LIST mode. The same sequence number was used for the remark and for
an associated ACL rule. The remark precedes the rule in the running-config because it is
assumed that the remark is for the rule with the same sequence number, or the group of rules
that follow the remark.
Example
FTOS(config-std-nacl)#remark 10 Deny rest of the traffic
FTOS(config-std-nacl)#remark 5 Permit traffic from XYZ Inc.
FTOS(config-std-nacl)#show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 Deny any
FTOS(config-std-nacl)#
Related

show config

Commands
show config
Display the current ACL configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show config
Command Modes
234
Enter a description of up to 80 characters.
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– displays the current ACL configuration.
• CONFIGURATION-STANDARD-ACCESS-LIST