Show Ip Accounting Access-List - Dell Force10 S4810P Reference Manual

Defaults Not enabled.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1

show ip accounting access-list

Display the IP access-lists created on the switch and the sequence of filters.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip accounting {access-list access-list-name | cam_count}
interface interface
Parameters
access-list-name
cam_count
interface
interface
in | out
Command Modes
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
238
Introduced on the Z9000.
Enter the name of the ACL to be displayed.
List the count of the CAM rules for this ACL.
Enter the keyword interface followed by the one of the following
keywords and slot/port or number information:
•
•
•
•
•
Identify whether ACL is applied on the ingress or egress side.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Added support for the 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Port Channel interface, enter the keyword port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.