Dot1X Authentication (Configuration) - Dell Force10 S4810P Reference Manual

Command History
Version 8.3.12.0
Version 8.4.2.1
Usage
The prerequisites for enabling MAB-only authentication on a port are:
Information
In MAB-only authentication mode, a port authenticates using the host MAC address even
though 802.1xauthentication is enabled. If the MAB-only authentication fails, the host is placed
in the guest VLAN (if configured).
To disable MAB-only authentication on a port, enter the no dot1x auth-type mab-
only command.
Related dot1x mac-auth-bypass
Commands

dot1x authentication (Configuration)

Enable dot1x globally. Enable dot1x both globally and at the interface level.
C-Series, E-Series TeraScale, S-Series, S4810
Syntax dot1x authentication
To disable dot1x on a globally, use the no dot1x authentication command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 7.6.1.0
Version 7.4.1.0
Related dot1x authentication (Interface)
Commands
220
Introduced on the S4810.
Introduced on the C-Series and S-Series.
• Enable 802.1X authentication globally on the switch and on the port (the dot1x
authentication command).
• Enable MAC authentication bypass on the port (the dot1x mac-auth-bypass
command).
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.