Seq Arp - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

When you have exhausted all the sequence numbers, this feature permits re-assigning a new

sequence number to entries of an existing prefix list.

resequence access-list

seq arp

Configure an egress filter with a sequence number that filters ARP packets meeting this criteria. This command is

supported only on 12-port GE line cards with SFP optics. For specifications, refer to your line card documentation.

seq sequence-number {deny | permit} arp {destination-mac-

address mac-address-mask | any} vlan vlan-id {ip-address | any

| opcode code-number} [count [byte] | log] [order] [monitor]

To remove this filter, use the no seq

destination-mac-

address mac-

address-mask

– resequences an access-list.

Enter a number from 0 to 4294967290.

Enter the keyword deny to drop all traffic meeting the filter criteria..

Enter the keyword permit to forward all traffic meeting the filter

Enter a MAC address and mask in the nn:nn:nn:nn:nn format.

For the MAC address mask, specify which bits in the MAC address

The MAC ACL supports an inverse mask; therefore, a mask of

ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of

00:00:00:00:00:00 only allows entries that match exactly.

Enter the keyword any to match and drop any ARP traffic on the

Enter the keyword vlan followed by the VLAN ID to filter traffic

associated with a specific VLAN. The range is 1 to 4094 and 1 to 2094

for ExaScale (you can use IDs 1 to 4094). To filter all VLAN traffic

specify VLAN 1.

Enter an IP address in dotted decimal format (A.B.C.D) as the target

IP address of the ARP.

Enter the keyword opcode and then enter the number of the ARP

opcode. The range is 1 to 16.

(OPTIONAL) Enter the keyword count to count packets the filter

(OPTIONAL) Enter the keyword byte to count bytes the filter

sequence-number command.