Permit - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

permit

Configure a filter to pass IP packets meeting the filter criteria.

C-Series, E-Series, S-Series, Z-Series, S4810

permit {ip | ip-protocol-number} {source mask | any | host ip-

address} {destination mask | any | host ip-address} [count

[byte] | log] [dscp value] [order] [monitor] [fragments]

To remove this filter, you have two choices:

ip-protocol-

Use the no seq sequence-number command if you know the filter's sequence

Use the no deny {ip | ip-protocol-number} {source mask | any

| host ip-address} {destination mask | any | host ip-

address} command.

Enter the keyword ip to configure a generic IP access list. The

keyword ip specifies that the access list will permit all IP protocols.

Enter a number from 0 to 255 to permit based on the protocol

identified in the IP protocol header. The S4810 range is 0 to 128.

Enter the IP address in dotted decimal format of the network from

which the packet was sent.

(OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D.

The mask, when specified in A.B.C.D format, may be either

contiguous or non-contiguous.

Enter the keyword any to specify that all routes are subject to the

Enter the keyword host and then enter the IP address to specify a

host IP address or hostname.

Enter the IP address of the network or host to which the packets are

(OPTIONAL) Enter the keyword count to count packets processed

by the filter.

(OPTIONAL) Enter the keyword byte to count bytes processed by

(OPTIONAL, E-Series only) Enter the keyword log to enter ACL

matches in the log.

(OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP

(OPTIONAL) Enter the keyword order to specify the QoS priority for

the ACL entry. The range is 0 to 254 (where 0 is the highest priority

and 254 is the lowest; lower order numbers have a higher priority). If

you do not use the keyword order, the ACLs have the lowest order

by default (255).