Dell Force10 S4810P Reference Manual page 257

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,

when specified in A.B.C.D format, may be either contiguous or non-

Enter the keyword any to specify that all routes are subject to the

Enter the keyword host and then enter the IP address to specify a

host IP address.

Enter this keyword dscp to deny a packet based on the DSCP value.

The range is 0 to 63.

Enter a flag or combination of bits:

(OPTIONAL) Enter one of the following logical operand:

Enter the application layer port number. Enter two port numbers if

using the range logical operand. The range is 0 to 65535.

The following list includes some common TCP port numbers:

Enter the IP address of the network or host to which the packets are

Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,

when specified in A.B.C.D format, may be either contiguous or non-

(OPTIONAL) Enter the keyword count to count packets processed

by the filter.

(OPTIONAL) Enter the keyword byte to count bytes processed by

ack: acknowledgement field

fin: finish (no more data from the user)

psh: push function

rst: reset the connection

syn: synchronize sequence numbers

urg: urgent field

eq = equal to

neq = not equal to

gt = greater than

lt = less than

range = inclusive range of ports (you must specify two ports

for the port command)

20 and 21 = FTP