Common Ip Acl Commands; Access-Class - Dell Force10 S4810P Reference Manual

Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Example
FTOS(config-ext-nacl)#show conf
!
ip access-list extended patches
FTOS(config-ext-nacl)#

Common IP ACL Commands

The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-
specific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an
implicit permit.
C-Series and S-Series (non-S4810) platforms support Ingress IP ACLs only.
The S4810 and Z-Series support both Ingress and Egress IP ACLs.
NOTE: Also refer to the

access-class

Apply a standard ACL to a terminal line.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax access-class access-list-name
To remove an ACL, use the no access-class access-list-name command.
Parameters
access-list-name
Defaults Not configured.
Command Modes LINE
Command History
Version 8.3.11.1
Version 8.3.7.0
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Commands Common to all ACL Types
Enter the name of a configured Standard ACL, up to 140 characters.
Introduced on the Z9000.
Introduced on the S4810.
section.
235