Cam-Acl - Dell Force10 S4810P Reference Manual

line
Defaults No banner is configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series
Usage A MOTD banner message is displayed only in EXEC Privilege mode after entering the enable
Information command followed by the password. These banners are not displayed to users in EXEC (non-
privilege) mode.
Related
banner exec
Commands
banner login

cam-acl

Allocate CAM for IPv4 and IPv6 ACLs.
C-Series, S-Series, Z-Series
Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number,
ipv4qos number l2qos number, l2pt number ipmacacl number
ecfmacl number [vman-qos | vman-dual-qos number}
Parameters
default
Enter a text string for your MOTD banner the message with your
delineator. The delineator is a percent character (%).
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command
– enables the display of a text string when you enter EXEC mode.
– sets a banner to be displayed after successful login to the system.
Use the default CAM profile settings and set the CAM as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
107