Cam-Audit Linecard; Clear Alarms - Dell Force10 S4810P Reference Manual

Command Modes CONFIGURATION
Command History
Version 9.1.(0.0)
Usage
You must reboot the switch after changing the parameter values for changes to take effect.
Information
Refer to the SDN chapter in the FTOS Configuration Guide for platform-specific instructions on
using this command.

cam-audit linecard

Enable audit of the IPv4 forwarding table on all line cards.
E-Series
Syntax cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all
ipv4-fib
interval
minutes
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 7.4.1.0
Usage Enables periodic audits of the software and hardware copies of the IPv4 forwarding table.
Information

clear alarms

Clear alarms on the system.
C-Series, E-Series, S-Series, Z-Series
Syntax clear alarms
Command Modes EXEC Privilege
Introduced on S4810.
Enter the keyword all to enable CAM audit on all line cards.
Enter the keyword ipv4-fib to designate the CAM audit on the
IPv4 forwarding entries.
time-in-
Enter the keyword interval followed by the frequency in minutes
of the CAM audit. Range: 5 to 1440 minutes (24 hours). Default: 60
minutes.
Introduced on the E-Series.
109