Dell Force10 S4810P Reference Manual page 151

Command History
Version 8.1.1.0
Version 7.8.1.0
Version 7.5.1.0
E-Series
Usage Fan speed is controlled by temperatures measured at the sensor located on the fan itself. The
Information fan temperatures shown with this command may not accurately reflect the temperature and
fan speed. For fan speed and temperature information, refer to your hardware installation
guide.
Example (E1200)
FTOS#show environment
-- Fan Status --
Tray Status Temp Volt Speed PEM0 PEM1 Fan1 Fan2 Fan3
-----------------------------------------------------
0 up < 50C 12-16V low/2100-2700 RPM up up up up up
1 up < 50C 12-16V low/2100-2700 RPM up up up up up
2 up < 50C 12-16V low/2100-2700 RPM up up up up up
3 up < 50C 12-16V low/2100-2700 RPM up up up up up
4 up < 50C 16-20V med/2700-3200 RPM up up up up up
5 up < 50C 12-16V low/2100-2700 RPM up up up up up
-- Power Entry Modules --
Bay Status
-----------------------------------------------------
0 absent or down
1 up
-- Line Card Environment Status --
Slot Status Temp PEM0 PEM1 Voltage
------------------------------------------------------
0 not present
1 not present
2 not present
3 not present
4 not present
5 not present
6 not present
7 not present
8 not present
9 not present
10 not present
11 booting 53C down up ok
12 not present
13 not present
-- RPM Environment Status --
Slot Status Temp PEM0 PEM1 Voltage
-------------------------------------------------------
0 active 48C down up ok
1 not present
-- SFM Environment Status --
Slot Status Temp PEM0 PEM1
--------------------------------------------------------
0 active 49C up up
1 active 47C up up
2 active 46C up up
3 active 48C up up
4 active 52C up up
5 active 50C up up
6 active 47C up up
Introduced on the E-Series ExaScale.
Added temperature information for the C-Series fans (refer to the last
example.)
Introduced on the C-Series.
Original command.
151