Reload - Dell Force10 S4810P Reference Manual

Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 8.1.1.2
Version 8.1.1.0
Version 7.5.1.0
E-Series
Related power-off
Commands

reload

Reboot FTOS.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax reload [conditional nvram-cfg-change]
Parameters
conditional
nvram-cfg-
change
Command Modes EXEC Privilege
Command History
Version 9.1(0.0)
Version 8.3.11.1
Version 7.6.1.0
Version 7.5.1.0
E-Series
Usage If there is a change in the configuration, FTOS prompts you to save the new configuration. Or
Information you can save your running configuration with the copy running-config command.
For information related to the BMP reload options, refer to the
chapter.
Use the conditional parameter if any configuration changes made to the nvram, such as stack-
group and fanout configurations, must be saved.
Related
Commands
138
NOTE: This option is supported on the E-Series only.
Introduced on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale E1200i.
Introduced on the C-Series.
Original command.
– powers off a line card or standby SFM.
Reload if the condition is true. A configuration change to the nvram
requires a switch reload. You must select
reload the switch.
Added 'conditional' parameter.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
• reset – resets a line card, RPM, or a failed SFM (TeraScale and ExaScale).
nvram-cfg-change to
Bare Metal Provisioning (BMP)