AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 519

Telephones
Console Procedure To program a single line/trunk:
PC Procedure
Copy Line/Trunk Assignments
Use this procedure to copy outside line/trunk button assignments, pool dial-out
code restrictions (Hybrid/PBX only), and (for operator positions only) Night
Service information from one extension to another extension or block of
extensions with identical requirements.
If you are copying assignments to a block of extensions and one of the
extensions in the block is in use, the display shows the Station Busy - Pls
Wait
message. Copying for the rest of the extensions in the block is delayed
until the busy extension becomes idle. The number of the busy extension is not
shown. If a DSS is attached, the LED associated with the busy extension is on.
If you exit instead of waiting for the busy extension to become idle, copying for
the rest of the extensions is canceled; however, the assignments that have
already been copied are not canceled.
If you are copying assignments from an operator position to a block of
extensions that includes both operator and nonoperator extensions, the
information is copied only to the operator positions; the nonoperator positions
are not affected. Similarly, if you are copying assignments from a nonoperator
position to a block of extensions that includes both operator and nonoperator
extensions, the information is copied only to the nonoperator positions; the
operator positions are not affected. The system does not provide an error tone
to signal that the copy did not work for all of the extensions in the block.
Summary: Copy Line/Trunk Assignments
Programmable by
Mode
Idle Condition
Extensions → Lines/Trunks → Dial ext. no. → Enter →
Entry Mode → Dial line/trunk no. → Enter → Exit → Exit
To program a block of lines/trunks:
Extensions → Lines/Trunks → Dial ext. no. → Enter →
Select trunk range → Toggle LED On/Off → Enter → Exit →
Exit
To program a single line/trunk:
[ F6 ] → [ F1 ] → Type ext. no. → [ F10 ] → [ F6 ] → Type Iine/trunk no.
→ [ F10 ] → [ F5 ] → [ F5 ]
To program a block of lines/trunks:
[ F6 ] → [ F1 ] → Type ext. no. → Select trunk range →
Toggle0 letter G On/Off → [ F10 ] → [ F5 ] → [ F5 ]
System manager
All
Telephone idle
Programming Procedures
4-169