AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 391

Lines and Trunks
Console Display/Instructions
6 Enter the extension asslgned as prlncipal user for the specifed line.
Line/Trunk xxx:
Enter principal ext for
Remote Forward/Coverage
Delete
Backspace Next
Exit
Enter
7 Assign or remove the extension as prlncipal
Select Enter or
Delete.
8 Continue to assign a prlncipal user to another line or trunk, or go to Step 9.
Select Next.
9 Save your entry.
Select Enter.
10 Return to the System Programming menu.
Select Exit two times.
QCC Queue Priority Level
Use this procedure to assign QCC queue priority level values (1 to 7) to each
loop-start, ground-start, and automatic-in tie trunk in your system. The value
assigned determines the order in which calls are sent to the QCC operator
positions. Call priority 1 is the highest priority, and 7 is the lowest priority.
NOTE:
This procedure applies to Hybrid/PBX mode only in a system that includes QCC
operator positions.
Summary: QCC Queue Priority Level
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Additional Information
xxx = line/trunk number entered in Step 4
SP:
"Entering an Extension"
ser.
U
Return to Step 6. The next line/trunk
will be displayed on Line 1.
System manager
Hybrid/PBX
Not required
Form 2c, System Numbering: Line/Trunk Jacks
4
1 t o 7
Yes
No
[ F10 ]
[ F10 ]
[ F5 ] [ F5 ]
Programming Procedures
PC
←
[ F8 ]
[ F9 ]
4-41