Pri Facilities - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

PRI Facilities

PRI Facilities
The procedures in this section provide the steps for programming the following
options for Primary Rate Interface (PRI) facilities connected to a 100D (DSI)
module:
Telephone Number
B-Channel Groups
Network Service
Copy Telephone Number to Send
Incoming Routing
Telephone Number to Send
Test Telephone Number
Timers and Counters
Terminal Equipment Identifier
Dial Plan Routing
Outgoing Tables
Network Selection Tables
Special Services Tables
Call-by-Call Service Table
NOTE:
If you are adding PRI facilities to an existing system, certain vaues must be set
correctly. To inspect or change these values, see "DS1 Facilities. " Do not start
these procedures until you have checked the following:
Type of DS1 Facility must be set to PRI.
Frame format must be specified correctly.
Zero code suppression must be specified correctly.
Clock synchronization source must be set to loop (derived from the
T1 line).
The settings for frame format and zero-code suppression must be consistent
with the options selected when the PRI connection was ordered.
If you are using ARS in connection with PRI, make sure you select voice, data,
or voice and data, as appropriate, when you perform the ARS "Voice and/or
Data Routing" procedure found in "Automatic Route Selection. "
Programming Procedures
4–111