AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 612

Automatic Route Selection
Console Display/Instructions
15 Return to the System Programming menu.
Select Exit two times.
Pool Routing
Use this procedure to identify the trunk pools on which to route calls to area
codes and/or exchanges included in ARS tables.
A maximum of six routes (numbered 1 through 6) can be specified for each
subpattern. Pool routing is programmed for Tables 1 through 16. Tables 17 and
18, the Default Toll and Default Local tables respectively, cannot be changed.
Summary: Pool Routing
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Pool Routing
Console Display/Instructions
1 Select the Tables menu.
System Programming:
Make a selection
System Extensions
Options
SysRenumber
Tables
Operator
LinesTrunks AuxEquip
Exit NightSrvce
4-262
Programming Procedures
Additional Information
System manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
Form 3g, Automatic Route Selection Default and Special
Numbers Tables
Not applicable
Not applicable
No
No
Tables ARS Sub A Pools or Sub B Pool
and pool route no. Enter
Enter Exit Exit
[ F8 ] [ F6 ] [ F3 ] or [ F10 ]
[ F10 ] Type pool dial-out code
Additional Information
PC
[ F5 ] [ F5 ]
Dial table no.
Dial pool dial-out code
Type table no. and pool route no.
[ F10 ] [ F5 ] [ F5 ]
PC
[ F8 ]